Installation guide


o
Power over Ethernet (PoE) Class 3 — If PoE is available, the LEDs will turn on.

o
External Power — Connect an external 12 VDC or 24 VAC power source to the power connector
block.
5. Check that the Connection Status LED indicates the correct state. For more information, see LED
Indicators on page15.
Assigning an IP Address
The camera automatically obtains an IP address when it is connected to a network.
NOTE: If the camera cannot obtain an IP address from a DHCP server, it will use Zero Configuration Networking
(Zeroconf) to choose an IP address. When set using Zeroconf, the IP address is in the 169.254.0.0/16 subnet.
The IP address settings can be changed using one of the following methods:
l Camera's web browser interface: http://<camera IP address>/
l ARP/Ping method. For more information, see Setting the IP Address Using the ARP/Ping Method on
page17
l Network Video Management software application (for example, Avigilon Control Center).
NOTE: The default camera username is admin and the default password is admin.
Accessing the Live VideoStream
Live video stream can be viewed using one of the following methods:
l Web browser interface: http://<IP address>/
l Network Video Management software application (for example, the Avigilon Control Center software).
NOTE: The default camera username is admin and the default camera password is admin.
Aiming the Dome Camera
1. Loosen the pan and tilt lock screws on the camera.
2. Turn the lens to the desired direction by panning and tilting the lens.
3. Once satisfied, tighten the pan and tilt lock screws to secure the dome camera’s position.
4. Rotate the azimuth control ring to set the image to the correct angle.
5. In the Camera Installation Tool or camera web browser interface, adjust the camera’s Image and Display
settings. From either applications, you can set the desired zoom position, and change the image rotation.
(Optional) Configuring Onboard Storage
To use the camera’s onboard storage feature, you must insert an SD card into the SD card slot.
It is recommended that the SD card have a capacity of 8GB or more, and a write speed of class 6 or better. If the
SD card does not meet the recommended capacity or write speed, the performance of the onboard storage
may suffer and result in the loss of frames or footage.
Assigning an IP Address 10