Installation guide

Figure 2: Dome camera mounted to a ceiling
6. Apply extra silicone sealant over the screw heads and allow to cure.
7. Apply silicone sealant around the edge of the camera that is screwed into the mounting surface.
WARNING — Only use UL listed mounting brackets suitable for the mounting surface and can sustain a
minimum 1.2 kg (2.6 lbs).
Connecting Cables
Refer to the diagrams in the Overview section for the location of the different connectors.
To connect the cables required for proper operation, complete the following:
1. If external input or output devices are part of the installation (for example: door contacts,relays, etc),
connect the devices to the I/O Terminals.
2. If an external microphone or external video monitor needs to be connected to the camera, connect the
devices to the camera Audio/Video Connector.
3. Connect a network cable to the camera’s Ethernet Port (RJ-45 connector).

o
Wrap the cable once around the interior base of the dome housing before you make the
connection. This will ensure the cable connector is not over-stressed and cause poor video
performance.

o
The Link LED will turn on once a network link has been established.
4. Connect power using one of the following methods:
9 Connecting Cables