Operating instructions

EXP5000 System Overview
Entegra EXP5000 PFD -20- 600-00142-000 Rev 01
2) Heading Bug (Hdg Bug)— Controlled by the right knob when
Hdg Bug is selected, the notched part of the magenta bug symbol
indicates the current Heading Bug value. The Heading Bug is
positioned on the selected side of the compass rose and remains
in partial view when the HSI is in 120° view and the Heading Bug
value is outside the current compass rose field of view. The range
is 001 to 360 degrees.
3)Altitude Bug (Alt Bug)—
Controlled by the right knob
when you select Alt Bug. The
notched part of the magenta
bug symbol indicates the
current altitude preselect
value. When the selected
value is outside the current altimeter field of view,
the Bug is positioned at the appropriate end of the
tape and remains in partial view (left). For SRV
aircraft, the Alt Bug is always uncoupled and
cannot be used to set the Autopilot. The Alt Bug displays on the
altitude tape and the range of values is the same as the altitude
tape (–1,000 feet to 35,000 feet).
Press the Alt Bug button to
switch between the Alt Bug
modes (1,000 ft., 100 ft.,
and 10 ft.). The default
adjustment position is
1,000 ft. Push the button to
select the mode, then
rotate the knob to adjust
the altitude for that mode.
4) Altitude Preselect—Displays the numeric value of the Altitude
Bug setting and, when enabled, the altitude that the autopilot is
commanded to capture and hold. When Alt Bug is selected, the
numbers appear as black on magenta.
5) Vertical Speed Indicator Bug (VSI Bug)—(SR20 and SR22
only) Controlled by the right knob when you select VSI Bug. The
notched part of the magenta bug symbol indicates the current
Partial
HollowSolid