Operating instructions

EXP5000 Buttons and Knobs
600-00142-000 Rev 01 -17- Entegra EXP5000 PFD
5) Left Knob—The function of the left knob changes depending on
the enabled button.
■ When Nav is enabled, the Crs Set label displays when you
can set a course, as shown in Table 2.1. For information
about setting a course, see Section 3.5, "Using GPS/VHF
Systems with the EXP5000" on page 29.
■ When Range/View is enabled, the left knob controls the HSI
view, and if applicable, the moving map range, as follows:
Nav, Bearing, and Aux Data Blocks
The Nav data block content varies depends on the source, as follows:
Table 2.1 Crs Set Labels
NAV Source GPS Nav Condition Left Knob Label
GPS 1 or GPS 2 GPS in Auto-Leg mode None
GPS 1 or GPS 2 GPS in OBS mode
VLOC 1 or VLOC 2 Tuned NavAid is a VOR
VLOC 1 or VLOC 2 Tuned NavAid is an ILS or LOC
Table 2.2 HSI Moving Map Range Labels
View Selection Left Knob Label
With moving map
Without moving map
Table 2.3 Primary Navigation Source
NAV Source Data Block Format
GPS 1 or GPS 2 ■ Waypoint Identifier
■ Desired Track to Waypoint
■ Distance to Waypoint
■ Time-to-Go to Waypoint
VLOC 1 or VLOC 2 (VOR Tuned) ■ “VOR”
■ VOR Frequency
■ Course
VLOC 1 or VLOC 2 (ILS or LOC Tuned)
■ “ILS” or “LOC”
■ Localizer Frequency
■ Course