Installation manual

Figure 17: Aircraft Setup Page with Datalink
Installation Manual
P/N 600-00175-000 Rev 04 MFD Feature Setup and Checkout
- 59 -
5.10 Aircraft Setup
The options on the Aircraft Setup Page depend on the aircraft model and selected options for that
aircraft. These options may include:
● Auxiliary Data
● Two-Way Datalink
● Broadcast Datalink
● Dimming Bus
Note: The available options are dependent on the aircraft model and additional purchased features.
Your aircraft may not have all options available.
➤ To configure the Aircraft Setup Page:
1. From Maintenance Mode, select Aircraft Setup. The Aircraft Setup Page displays:
2. Set the options that appear on the Aircraft Setup Page. These options will vary depending on the
aircraft model and optional features selected.
Aircraft Setup options are described in the following sections:
■ Section 6.6, “ORBCOMM Satellite Reception (EX500 Only)” on page 72
■ Section 5.10.2, “Broadcast Datalink Setup” on page 61
■ Section 5.10.3, “Dimming Bus Setup” on page 63
3. When you are done, press Save. Press Cancel to exit without saving changes.
4. Changes do not take effect until the MFD has been restarted. From the Maintenance Mode Page,
press Restart System.