Installation manual

Installation Manual
Radar Sensor Setup P/N 600-00175-000 Rev 04
- 58 -
5.9.7 Radar Communications Troubleshooting
If there is a communication or data error between the RADAR sensor and the MFD, one of the
following messages will display on the bottom of the screen.
Table 23: Radar Sensor Error Messages
Message Meaning/Action
Radar Sensor Data Is Invalid Data received from the RADAR sensor system can not be used by the EX500/
EX600.
■ Cycle power on the EX500/EX600.
■ See the Installation and User’s Manual for your radar system for
troubleshooting guidance.
Radar Sensor Has Failed The RADAR sensor system has reported an error.
■ Check R/T configuration module error log.
■ See the RADAR Sensor Installation and User’s Manual for troubleshooting
guidance.
Radar Sensor Is Not
Communicating
Communication of return data from the RADAR sensor to the MFD has been lost.
■ Verify that the RADAR sensor is turned on and valid.
■ Verify that the EX500/EX600 is properly seat in its tray.
■ Verify system wiring.
Invalid GPS Data and Radar is ON The RADAR is ON and the EX500/EX600 has no ground speed data available
from the GPS/FMS.
■ Verify the GPS/FMS is ON and valid.
■ Verify system wiring.
■ See the Installation and User’s Manual for your radar system for
troubleshooting guidance.
Radar Automatic Standby Disabled The RADAR is ON, the EX500/EX600 RADAR automatic standby mode is
disabled, and the EX500/EX600 has no ground speed data available from the
GPS/FMS.
■ Verify the GPS/FMS is ON and valid.
■ Verify system wiring.
■ See the Installation and User’s Manual for your radar system for
troubleshooting guidance.