Installation manual

Installation Manual
Radar Sensor Setup P/N 600-00175-000 Rev 04
- 46 -
5.9 Radar Sensor Setup
The EX500/EX600 supports a number of different radar types, briefly described in Table 7, “EX500
Part Numbers,” on page 11 or Table 8, “EX600 Part Numbers,” on page 11. The available
configuration options, described in Table 21, “Radar Options,” on page 48 are radar specific.
This section contains the following information:
● Supported Radar Features, page 46
● Setting up Radar Support, page 48
● Radar Configuration Options, page 48
● Adjusting the Roll Trim, page 49
● Calibrating the Radar System, page 49
● Radar Checkout, page 57
● Radar Communications Troubleshooting, page 58
5.9.1 Supported Radar Features
Table 20 describes the features available in each type of supported radar.
Table 20: Radar Feature Matrix
Radar Type Range
Values
Scan Arcs supported
# of colors
Multiple Ind
Stabilization
Stab on-off ctrl
Auto-Tilt
VP
Roll Trim adj
ARL/PAC
Target Alert
Azim Lines
other than 0×
Bendix/King
RT-131A (RDR-130/RDR-150)
with:
■ AT-133A/AT-133A INV
■ DA-144A/A-144A INV
5, 10, 20, 40, 80,
160
90° 3
*
RT-131A (RDR-1100) with
DA-1203A antenna
10, 20, 40, 80,
160, 240
60°, 120° 3
•
*
•
ART-161A (RDR-160) 5, 10, 20, 40, 80,
160
90° 3*
RS-811A (RDS-81) 10, 20, 40, 80,
160, 240
90° 4
•••
*
•
RS-181A (RDS-82) 10, 20, 40, 80,
160, 240
90° 4
•••
*
•
RS-181A-VP (RDS-82VP) 10, 20, 40, 80,
160, 240
90° 4
•••
*
••
RS-841A (RDS-84) 5, 10, 20, 40, 80,
160, 240, 320
120° 4
••
*
•
RS-841A-VP (RDS-84VP) 5, 10, 20, 40, 80,
160, 240, 320
120° 4
••
*
••
RS-861A (RDS-86) 5, 10, 20, 40, 80,
160, 240, 320
120° 5
•• • ••
RS-861A-VP (RDS-86VP) 5, 10, 20, 40, 80,
160, 240, 320
120° 5
•• ••••