Operating instructions

Using the EXP5000 for Approaches
Entegra EXP5000 PFD -56- 600-00157-000 Rev. 06
4) Just prior to reaching MDA, select ALT on the autopilot to
command altitude hold.
Flying a Back Course Localizer Approach
The EXP5000 is designed to fully support flying back course localizer
approaches. To perform a back course localizer approach, ensure the
front course value is set via the EXP5000 Course Set knob. As soon
as the EXP5000 determines that it is established on the back course
localizer, the HDI source label annunciates LOC BCRS and both the
HDI and CDI display correct sensing. There is no further pilot action
required. The VDI will not be displayed for back course localizer
approaches.
Missed Approach
Prior to missed approach, disconnect the autopilot, ensure the aircraft
is trimmed for the power setting, establish a climb attitude and use
the EXP5000 Alt Bug to set the desired missed approach altitude. On
the climbout, select HDG or NAV (depending on missed approach
instructions) on the autopilot, press ALT and VS simultaneously on
the autopilot, and press OBS on the Navigator to continue the
coupled missed approach.
Note: For coupled approaches, the Autopilot may have to be set to reverse
mode. Please consult the Autopilot POH for proper operation.