User Manual
Table Of Contents
- Contents
- Introduction
- Installation and Setup
- Connecting the Dock
- Installing EuControl Software
- Updating Dock Firmware
- Installing and Connecting Pro Tools | Control
- Enabling EUCON in Pro Tools
- Confirming EUCON
- Connecting a Second Workstation
- Connecting a Footswitch
- Kensington Lock
- Powering-On Your System After Initial Setup
- Optimizing EuControl After a Pro Tools Update
- Dock Surface Controls Overview
- Using the Dock with Pro Tools
- Soft Keys
- EuControl Software
- Appendix A: Specifications
- Appendix B: Avid S3 Dock Link Kit
- Appendix C: Compliance Information
Dock Surface Controls Overview 15
Dock Surface Controls Overview
This section provides an overview of the surface controls on the Dock when using it with the Control app and EUCON-compatible
applications.
The primary function of each switch is labeled directly on the switch. The secondary (
SHIFT or ALT) function is labeled next to
the switch.
For audio workflows, see
Using the Dock with Pro Tools.
Pro Tools | Dock top panel
1 – iPad Stand
2 – Soft Knobs
3 – Soft Keys
4 – Left Control
5 – Right Control and Vertical Touchstrip
6 – Wheel and Horizontal Touchstrip
7 – Transport
8 – Channel Strip
9 – Control Room/Monitor
10 – Surface SHIFT
SHIFT
Loop Rec
Write to
Capture
Punch
Match
Auto
Preview
Suspend
Preview
Punch
1234
1
2
3
4
Rec Mode
Mark Out
Scroll V
User 1
User 2
Control Room
60
40
30
20
10
5
0
6
12
Monitor
Nudge
Nudge
BACK+
P P ROLL/
SHIFT
USER
Scroll H
Mark In
Do to All
Workstation
All/Sel
Start
End
Punch
Next
Preview
Capture
Clip
Shuttle
Jog
ZoomZoom
Bank
Bank
H
V
ALT
Read
Wndow
Off
Trim
Touch
Latch
Cancel
Save
OKApp
Move
Sel
Do to
Sel
Susp
Auto
Auto
Join
Latch
Touch
JoinWrite
Solo
Mute
Rec
Sel
1
2
3
4
7
8
9
6
10
2
5
10