User Manual

Chapter 3: Exploring Rigs 49
General Effects Controls
Sync
The time-based effects in Eleven Rack (such as
Chorus, Delay and Flanger) can be set to syn-
chronize with Rig or Session tempo (including
tempos set with the Tap Tempo button).
Most Rigs are not set up to sync to Rig or Session
tempo by default. You may need to turn on the
Sync parameter in the effect you want to sync.
When the Sync control on these effects is set to
a rhythmic subdivision of the incoming tempo,
the effect locks to it. When Sync is set to Off, or
the Rate or Delay control is moved, the control
takes over, and the rate of modulation or delay
can be set by hand.
Delay+ and Fine
You’ll see these two controls when working with
some delay effects. Delay+ quadruples the avail-
able delay time, for when longer echoes are
needed. Fine switches the delay’s Rate control
into a fine-adjust mode, where the delay time
can be set by the millisecond with the Scroll
wheel. Press Fine again to return the Scroll
wheel to normal operation.
Don’t Forget to Save!
When you’ve got things tweaked just right,
make sure to save your settings. If you switch to
a different Rig before saving, you’ll lose your
changes. To save the current state of the Rig
you’re working on to the same Rig memory lo-
cation, press the Save button, then press it
again.
See “Saving Your Work” on page 25.