Specifications
Table Of Contents
- Contents
- Introduction
- Installation and Authorization
- Session and Track Features
- Advanced Editing Features
- Advanced Automation Features
- AutoJoin with Latch Mode
- Touch/Latch Mode
- Trim Mode
- Composite Automation Playlist
- Copy Track Automation to Sends
- AutoMatch
- Prime Controls for Writing Automation in Latch Mode
- Glide Automation
- Trim Automation
- Write Automation to the Start, End, or All of a Track or Selection
- Write Automation to the Next Breakpoint or to the Punch Point
- Overwrite or Extend Mute Automation
- Snapshot Automation
- Preview Automation
- Capture Automation
- VCA Master Track Automation
- Surround Features
- Pro Tools Audio Connections for 5.1 Mixing
- Configuring Pro Tools for Multichannel Sessions
- Default I/O Selectors in I/O Setup
- 5.1 Track Layouts, Routing, and Metering
- Routing Audio for Surround Mixing
- Multichannel Audio Tracks
- Multichannel Signal Routing
- Paths in Surround Mixes
- Example Paths and Signal Routing for a Surround Mix
- Introduction to Pro Tools Surround Panning
- Output Windows
- Surround Panner Controls
- Panning Modes
- Divergence and Center Percentage
- LFE Faders in Multichannel Panners
- Pan Playlists
- Surround Scope Plug-In
- Video Features
- Included Plug-Ins
- Index
Complete Production Toolkit 2 Guide62
Punching Automation Values for
All Controls
You can punch all captured automation values
to another location on their corresponding
tracks (except those tracks with their Automa-
tion Mode set to Off).
To punch the automation values of all controls:
When you reach a location where you want to
apply the captured automation states, Alt-click
(Windows) or Option-click (Mac) the Punch
Capture button. Any track set to Read or Touch
are set to Latch. Any tracks set to Off are unaf-
fected.
To punch the automation values of all controls on
selected tracks only:
When you reach a location where you want to
apply the captured automation states, Alt-Shift-
click (Windows) or Option-Shift-click (Mac) the
Punch Capture button. Any selected tracks set to
Read or Touch are set to Latch. Any selected
tracks set to Off are unaffected.
Capture and Trim Mode
The Capture and Punch Capture commands
work with Trim automation in the same way as
regular automation. Pro Tools saves Trim status
when capturing, so if you attempt to punch cap-
tured Trim values while displaying a non-Trim
automation playlist, Pro Tools will automati-
cally apply the values to the corresponding Trim
playlist.
Punch Capture and “Write To”
Commands
After issuing a Punch Capture command, the af-
fected controls are writing automation (in Latch
mode), so any of the Write Automation To com-
mands can be used to extend the punched value
in the same manner as other automation.