User's Manual
Table Of Contents
- Contents
- Introduction
- Installation and Setup
- Pro Tools | Carbon Front Panel Operation
- Pro Tools | Carbon Back Panel Connections
- Configuring Pro Tools
- DSP Mode for Low-Latency Monitoring
- Appendix A: Specifications
- Appendix B: Pro Tools | Carbon Core Audio Devices
- Appendix C: Pro Tools | Carbon Pin Out Diagrams
- Appendix D: Network Port Usage

Appendix A: Specifications 38
Monitor Outputs
Headphone Outputs
Digital I/O ADAT
Synchronization
Back panel 1⁄4-inch TRS outputs L–R
Frequency Response 20 Hz to 20 kHz, ±0.1 dB
SNR –120 dB (A-weighted)
Dynamic Range 120 dB (A-weighted)
THD 1 kHz @ –1 dBFS –110 dB (0.0003%)
Maximum Output Level +24 dBu
Crosstalk –135 dB @ 1 kHz
Connector Type 1⁄4-inch TRS Balanced
Front panel 1/4-inch TRS stereo 1–4
Power 100 mW into 300 ohm; 200 mW into 32 ohm
Frequency Response 20 Hz to 20 kHz, ±0.1 dB
SNR –116 dB (A-weighted)
Dynamic Range 116 dB (A-weighted)
Total Harmonic Distortion + Noise Ratio 32 Ohm: –87 dB (0.0045%)
300 ohm: –100 dB (0.001%)
Connector Type 1⁄4-inch TRS Stereo
Back panel optical ports 1 and 2
Format ADAT Digital Lightpipe with S/MUX
Supported Sample Rates 44.1, 48, 88.2, 96, 176.4, 192 kHz
Channel Assignments (44.1–48 kHz) Port 1 = Channels 1–8, Port 2 = Channels 9–16
Channel Assignments (88.2–96 kHz) Port 1 = Channels 1–4, Port 2 = Channels 5–8
Channel Assignments (176.4/192 kHz) Port 1 = Channels 1–2, Port 2 = Channels 3–4
Connector Type Optical TOSLINK
Connector Type BNC
Synchronization Sources Internal, ADAT, Word Clock










