User's Manual
Table Of Contents
- Contents
- Introduction
- Installation and Setup
- Pro Tools | Carbon Front Panel Operation
- Pro Tools | Carbon Back Panel Connections
- Configuring Pro Tools
- DSP Mode for Low-Latency Monitoring
- Appendix A: Specifications
- Appendix B: Pro Tools | Carbon Core Audio Devices
- Appendix C: Pro Tools | Carbon Pin Out Diagrams
- Appendix D: Network Port Usage
Configuring Pro Tools 24
Pro Tools | Carbon Output Setup
In addition to line and ADAT outputs, Pro Tools | Carbon has a dedicated Main stereo monitor output, two additional Alternate ste-
reo monitor output paths, and four dedicated Headphone outputs.
Main and Alt Monitor Paths
The Main monitor output path and the two Alt monitor paths can be enabled or disabled in the Hardware Setup. When enabled, each
appears color coded in the Output page of the I/O Setup. Each stereo monitor path has a fixed output assignment:
Main
The Main monitor path is always assigned to the 1/4-inch TRS stereo monitor outputs.
Alt 1
The Alt 1 monitor path is always assigned to the DB25 line outputs 1–2.
Alt 2
The Alt 2 monitor path is always assigned to the DB25 line outputs 3–4.
Headphone Outputs
Each Headphone output can be assigned to either mirror the Main monitor path or use its own dedicated path.
AFL/PFL Path and Pro Tools | Carbon
The AFL/PFL Path is used only for AFL and PFL Solo Modes. If you do not intend to use Pro Tools AFL and PFL Solo Mode fea-
tures, disable the
AFL/PFL Path to make more system resources available for other audio routing and processing tasks.
I/O Setup, Output page