User Manual

Chapter 6: System Setup 77
Configuring HD MADI Controls
To configure controls for HD MADI:
1 Choose Setup > Hardware.
2 From the Peripherals list, select either
HD MADI Port 1 or HD MADI Port 2 and config-
ure the options.
3 When you are finished, click OK.
Configuring 192 I/O and
192 Digital I/O Controls
To configure controls for a 192 I/O:
1 With the 192 I/O selected in the Peripherals
list, click the Analog In tab for the following op-
tions:
• You can set your operating level on a chan-
nel-by-channel basis by selecting Reference
Level +4 dBu or –10 dBV. These settings
correspond to two different input connec-
tors on the back of the 192 I/O. See the
192 I/O Guide for more information.
• Each of the analog channels in the 192 I/O
has two Input Trims, labeled A and B, for
precisely calibrating and switching levels.
You can select Input Trim A or B on a chan-
nel-by-channel basis. See the 192 I/O Guide
for more information.
•You can select Soft Clip on a channel-by-
channel basis. The Soft Clip limiter attenu-
ates the incoming analog signal, providing
extra protection from temporary clipping
transients that can cause digital distortion
when they exceed the maximum input of
the unit. With Soft Clip enabled, 192 I/O
supports an additional 4 dB of headroom
by rounding off the top 4 dB to the clip
point. This is useful for eliminating stray
transients.
2 Click the Analog Out tab for the following op-
tion:
For detailed information about configuring
HD MADI, see the HD MADI Guide.
HD MADI Hardware Setup
The settings for HD MADI Port 1 and
HD MADI Port 2 are linked. Any changes
are global regardless of which is selected in
the Peripherals list.
Hardware Setup for 192 I/O, Analog In page