User Manual

Chapter 44: Plug-In and Hardware Inserts 993
Creating and Editing Plug-In Maps
To create a custom map of plug-in parameters:
1 Open the plug-in whose mapping you want to
customize.
2 Put the plug-in into Learn mode. The plug-in
is focused on the control surface, but with a
blank page of controls, ready for mapping.
3 In the plug-in window, click the plug-in pa-
rameter you want to map. The parameter name
appears in the Parameter menu.
4 On the control surface, do one of the follow-
ing:
• Turn the encoder or press the channel Se-
lect switch where you want to map the pa-
rameter.
– or –
• If the control surface is in Flip mode, move
the fader or press the channel Select switch
where you want to map the parameter.
5 Repeat steps 3-4 for each parameter you want
to map.
6 Take the plug-in out of Learn mode.
To change parameter mapping in a plug-in map:
1 Open the plug-in whose custom map you
want to change.
2 Choose the map you want to change from the
Map Preset pop-up menu.
3 Put the plug-in into Learn mode. The plug-in
is focused on the control surface.
4 Do the following for each parameter mapping
you want to change:
• In the plug-in window, click the new plug-
in parameter you want to map. The param-
eter name appears in the Parameter menu.
– and –
• On the control surface, page to the encoder
or switch where you want to change the
mapping, and turn the encoder or press the
switch.
5 Take the plug-in out of Learn mode.
To remove parameter mapping from a plug-in map:
1 Open the plug-in whose custom map you
want to change.
2 Choose the map you want to change from the
Map Preset pop-up menu.
3 Put the plug-in into Learn mode. The plug-in
is focused on the control surface.
4 Do the following for each parameter mapping
you want to remove:
• Make sure the Parameter menu displays No
Control.
– and –
• On the control surface, page to the encoder
or switch where you want to remove the
mapping, and turn the encoder or press the
switch.
5 Take the plug-in out of Learn mode.
Plug-Ins are automatically taken out of
Learn mode when moved to a different
insert position, made inactive, or converted
between TDM and RTAS formats.