Owner`s manual

STEP 1: If media is already loaded in filter tank proceed to Step 4. Otherwise, use the fillport wrench

provided to remove the fillport cap (Refer to Figure 2) by turning it counter-clockwise.

STEP 2: DO NOT REMOVE THE WHITE FILLPORT SCREEN! Use the fill funnel provided and add

the required amount of media (see unit specifications) to the filter tank. Do not overfill the tank.

At least 14” of freeboard (empty space) is required at the top of the media tank to allow for

proper bed expansion during backwash. Any excess media may be saved for future

replenishment.

STEP 3: Clean any media out of the fillport cap threads. Do not reinstall the fillport cap until Step 9.

STEP 4: Place softener tank on right side with inlet/outlet facing left. Place filter tank on left with

inlet/outlet facing right.

STEP 5: Attach the control valve assembly to the front inlet opening of the filter tank and outlet opening

of the softener tank. Attach the straight pipe adapter to the back outlet of the filter tank and

inlet of the softener tank. HAND TIGHTEN UNION NUTS ONLY. DO NOT OVERTIGHTEN.

Installation Instructions

Filter Tank

Softener Tank

Fillport Cap

FIGURE 2: Tank Positioning and Fillport Location