Owner`s manual

1. Set Time of Day:

Time of day should only need to be set after extended power outages or when daylight saving time begins or

ends. If an extended power outage occurs, the time of day will flash on and off indicating that the time should

be reset.

STEP 1 -- Press SET CLOCK

STEP 2 -- Current Time (hour): Set the hour of the day using or buttons. AM/PM toggles after

12. Press next to go to step 3.

STEP 3 -- Current Time (minutes): Set the minutes using or buttons. If it is desired to go back up

to the previous step press regen button once. Pressing next will exit Set Clock and return to

the general operating display.

2. Programming:

NOTE: The manufacturer has preset the unit so that the gallons between regenerations will be automatically

calculated after the hardness is entered.

STEP 1 -- Press next and simultaneously for 3 seconds.

STEP 2 -- Hardness: Set the amount of hardness in grains per gallon (default 20) using the or

buttons. The allowable range is from 1 to 150 in 1 grain increments.

Press next to go to step 3. Press regen if you want to exit.

STEP 3 -- Day Override: The manufacturer has factory set this at 3 days as the default. This is the

maximum number of days between regenerations. A regeneration initiation will be called

for on that day even if a sufficient number of gallons were not used to call for a

regeneration. Set the day override using or buttons (3 is recommended). Press next

to go to step 4. Press regen if you need to return to the previous step.

Programming Procedures for the AFS