User guide

Artist Control User Guide6
To remove the riser brackets:
1 Slide the side panels off.
2 Press the tabs to release the riser brackets.
3 Lift the riser bracket out of the Artist Control to remove
Attaching an Artist Control to Additional Units
An Artist Control can be physically attached to up to four Artist Mixes and one Artist Transport to form a larger, stable control
surface.
To join an Artist Control to an Artist Mix:
1 On the Artist Control, use a #2 Phillips screwdriver to remove the two silver screws. The screws may be tight, so you may have
to use some force.
If you are using multiple units, see “Surfaces” on page 30 to use EuControl to arrange the units in the desired order.
Removing screws from the bottom panel