Specifications

Safety Compliance
Safety Statement
This equipment has been tested to comply with USA and Cana-
dian safety certification in accordance with the specifications of
UL 60065, 7th Ed., 2007-12-11; CAN/CSA C22.2 No. 60065-03,
1st Ed., 2006-04 + A1:2006; EN 60065:2002 +A1:2006
+A11:2008 + A2:2010 + A12:2011; IEC 60065:2001 + A1:2005
+ A2:2010. Avid Technology Inc., has been authorized to apply
the appropriate NRTL mark on its compliant equipment.
Warning
Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this equipment near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators, heat reg-
isters, stoves, or other equipment (including amplifiers) that pro-
duce heat.
9) Do not defeat the safety purpose of the polarized or ground-
ing-type plug. A polarized plug has two blades with one wider
than the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are provided
for your safety. If the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete outlet.
10) Protect power cords from being walked on or pinched partic-
ularly at plugs, convenience receptacles, and the point where they
exit from the equipment.
11) Only use attachments/accessories specified by the manufac-
turer.
12) For products that are not rack-mountable: Use only with a
cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the equipment. When a cart is used, use caution when
moving the cart/equipment combination to avoid injury from
tip-over.
13) Unplug this equipment during lightning storms or when un-
used for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is
required when the equipment has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the equipment, the equipment has been
exposed to rain or moisture, does not operate normally, or has
been dropped.
15) For products that are a Mains powered device:
The equipment shall not be exposed to dripping or splashing and
no objects filled with liquids (such as vases) shall be placed on
the equipment.
Warning! To reduce the risk of fire or electric shock, do not ex-
pose this equipment to rain or moisture.
16) For products containing a lithium battery:
CAUTION! Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
17) For products with a power switch:
The main power switch is located on the back panel of the D-Con-
trol; it should remain accessible after installation.
18) The equipment shall be used at a maximum ambient tempera-
ture of 40° C.
Do not attempt to service the equipment. There are no
user-serviceable parts inside. Please refer all servicing to
authorized Avid personnel.
WARNING
To reduce the risk of electric shock, do not expose this
equipment to rain or moisture.
Any attempt to service the equipment will expose you to a
risk of shock and will void the manufacturer’s warranty.
SPECIAL WARNING REGARDING VENTILATION:
Do not install XMON anywhere or in any way that blocks free
air flow at any time around the back panel of the unit.
SPECIAL WARNING REGARDING AMBIENT
TEMPERATURE:
Before powering on the unit, be sure to allow it to reach room
temperature. The unit includes some components that are
sensitive to cold temperatures, so it is recommended that
you unpack the unit and allow it to acclimate before turning it
on for the first time.