Specifications

Chapter 3: Using XMON 9
Chapter 3: Using XMON
This chapter explains how to use XMON with S6 and includes the following sections.
• “XMON to EUCON Mapping” on page 9 (all systems)
• “Using XMON with S6” on page 10
XMON to EUCON Mapping
This section clarifies the terminology used for the XMON and S6.
Control Room
The Control Room section on S6, MC Pro and System 5-MC can route input sources to three sets of outputs.
Main Spkrs Routes selected source(s) to the Main 1–8 (7.1-channel) outputs on the XMON hardware.
Alt 1 Spkrs Routes selected source(s) to the Alt 1–8 (7.1-channel) outputs on the XMON hardware.
Alt 2 Spkrs Feeds selected source(s) to the Mini 1–2 (stereo) outputs on the XMON hardware, on the TB/LB/UTIL connector
(XLR-M 6–7).
Monitors A–E
The Monitor section can control the following levels, as available on your system.
Mon A Controls the output level of the Headphone Output on the XMON Control Cable Breakout Adapter.
Mon B Controls the output level of the XMON CUE OUTPUT 1-2 (StLS L/R).
Mon C Controls the output level of the XMON CUE OUTPUT 3-4 (Cue 1 L/R).
Mon D Controls the output level of the XMON CUE OUTPUT 5-6 (Cue 2 L/R).
Mon E Controls the output level of the XMON CUE OUTPUT 7-8 (Cue 3 L/R).
Monitor D and E
To focus Monitor E controls from S6:
1 Open XMON EUCON Software and click to show the Main tab.
2 Click the box next to Control from surface to toggle it between MonD (the default setting) and MonE. On the Master Module
Touchscreen, Monitoring page, the lower left knob follows the selection.
Figure 8. Main tab in XMON EUCON Software