Specifications

Chapter 2: Software Configuration 7
Confirm Installation
To confirm installation and communication:
1 Make sure you have enabled EUCON as explained in “Enabling EUCON in Pro Tools” on page 6.
2 Open a Pro Tools session if one is not already open.
3 For System 5 only, do the following:
• On the System 5 CM401 Main Panel, select
EUCON Setup and attach to your Pro Tools worksta-
tion. (If you do not know how to attach a workstation, see “Attaching a Pro Tools Workstation to
System 5” on page 8.)
4 Verify the Mix window displays a blue-green border around Pro Tools tracks.
5 For System 5 only, verify that the CM401 Main Panel EUCON channels display the correct Pro Tools
tracks.
Attaching a Pro Tools Workstation to MC Pro or System 5-MC
To connect the MC to your workstations:
1 Make sure the MC Client is running on all workstations, then press the Strip Control Setup key on
the right side of the MC.
The Touchscreen displays all workstations available on the network in the right pane. There are two
choices: None/Disconnect and Your Workstation (showing computer name, user name, and operating
system).
2 Touch a Workstation key on the left of the Touchscreen. These buttons map to the physical
Workstation keys on the upper right of the MC. Touch the Workstation name in the list to assign it to
the selected number.
3 Repeat for each workstation to assign them to Workstation keys.
4 Press the Strip Control Setup key again to exit Workstation assignment mode.
For more information, see the MC Installation Guide.
Color outlines in the Mix window showing currently banked tracks