Specifications

Chapter 3: Using XMON 13
Speaker Management
Speaker Mapping
The Speakers buttons at the bottom of the Control Room Setup screen correspond to the eight outputs for the currently selected
Control Room feed: Main, Alt, Mini.
Speakers On and Off
The Speakers outputs are toggled on and off by clicking the eight buttons on the Control Room Setup screen.
• A yellow button indicates the speaker output is on.
• A gray button indicates the speaker is off.
Master Speaker On and Off
The far left Speakers button (labeled On in the figure above) is a master speaker on/off toggle switch.
• Clicking the yellow
On button turns all speakers off.
• Clicking the gray
Off button toggles speakers on that were previously active before the Off button was pressed.
Additional Information
The following XMON features are currently not supported in the XMON EUCON Software Application:
• Linking Monitor Output levels
• Output level trim mode
• Calibration mode
• Mono Switch
• Individual Output Trim Mode
• Broadcast Mode for AFL and PFL monitoring
• Cue Outputs 5–6 are not accessible via EUCON
• Headphone / Cue Talkback Dim
• Auto Talkback Mode
• Listen Mic level Control
• Listen Mic Select Switches
The following instructions are specific to MC Pro and System 5-MC. For Avid S6, see the S6 Guide (included with other S6 doc-
umentation in the download available in your Avid Master Account.
When Alt 2 Spkrs is selected on the MC Pro, the Control Room Setup screen speaker selector array shows only the two speakers for
the Mini output feed.
Turning Control Room Speakers on and off