Specifications

Chapter 3: Configuring VENUE and Pro Tools 15
7 Click Apply. In the dialog box that appears,
click
OK.
The system restarts with HDx or MADI inputs
active. A history Show file of the previous con-
figuration is also created and stored in
Filing > History.
Adjusting Input Gain in Input Mode
In Input mode, input channel gain is adjusted
using the input gain encoders. Digital gain (-20
dB to +18 dB) is available for all HDx or MADI
inputs.
When switching from active Stage inputs to In-
put mode, all gains for HDx or MADI input
channels are set to 0 dB.
When switching from Input mode to active
Stage inputs, all digital gain settings are re-
placed by pre-existing Stage input channel gain
settings.
Enabling Redundant Outputs
(HDx and MADI with VENUE Software 2.8.5
and Higher Only)
To enable redundant outputs:
1 Put your system into Config mode.
2 Go to the Options page and click the System
tab to access the System Configuration page.
3 Click Edit.
4 Do one of the following depending on your
configuration:
• If you have two HDx cards installed, click
Enable HDx 2, an click Copy Stage 1 (or
Stage for Mix Rack) Outputs to HDx 2.
• If you have an HDx card installed in slot 1
(HDx1) and a MADI card installed in slot 2
(MADI 2), and you want to copy HDx , click
Enable MADI 2 and click Copy Stage 1 (or
Stage for Mix Rack) Outputs to MADI 2.
• If you have a MADI card installed in slot 1
(MADI 1) and a HDx card installed in slot 2
(HDx2), and you want to copy the MADI 1
outputs to HDx 2 outputs, click
Enable
HDx2
and click Copy Stage 1 (or Stage for
Mix Rack)
Outputs to HDx 1.
• If you have two MADI cards installed
(MADI 1 and MADI 2), and you want to
copy MADI 1 outputs to MADI 2, click
En-
able MADI 2
and click Copy Stage 1 (or
Stage for Mix Rack) Outputs to MADI 2.
5 Click Apply.
Stage 1 (or Stage for Mix Rack), inputs are cop-
ied to the second card’s outputs, and all assign-
able inputs and outputs are available for each
option card.
If you want to revert to the previous configu-
ration, in the Show Folder column select the
most recent Show file from the Most Recent
Changes folder, and click Load.
You can use Satellite Link to control multiple
Pro Tools systems from one computer. See
the Satellite Link Guide for information.