User guide

System 5 Digital Audio Mixing System User Guide90
Mix Bus Routing
The 16 Mix Bus sections consist of individual busses in a defined pan format. For example, one section with an LCRS format uses
four busses, another section with a 5.1 format uses six busses. A system with 16 mix busses could have eight sections each with
a stereo format.
Route a Channel to a Mix Section
To route the post-fader channel signal to a Mix bus:
1 Press the MIX route key below the function switches. (See “GRP and MIX route switches” on page 89.)
This assigns the first eight Mix sections that have been defined in eMix to the knobset.
2 Press the  key to display additional Mix Routing pages if there are more than eight.
3 Press the lower switch to the left of the knob to assign that section.
4 Press the knob’s center switch to display the individual mix bus sections on the knobset.
When an individual section is assigned to the knobset, the lower switch to the left of the knob toggles that bus on/off.
5 Press the Pan to: key to switch Pan in/out for the Mix sections.
This key is active only when accessing the Mix or Group Bus routing pages. The key lights dimly in other modes to show that
Pan is active in Mix and/or Group routing. The MIX route key also lights dimly in other modes to show that channel is assigned
to one or more busses.
Assignments and pan settings are remembered when routing is toggled off and on.