User guide
Table Of Contents
- Contents
- Introduction to System 5
- Master Facilities and Channel Strip
- Control, Layouts and Snapshots, and Linking
- Chapter 8: Machine Control (S5P Only)
- Chapter 9: Control Groups and Multi Format Masters
- Chapter 10: Layouts and Snapshots
- Chapter 11: Linking (S5P Only)
- Chapter 12: Dynamic Automation (S5P Only)
- Chapter 13: GPI/O Event System
- Chapter 14: CM403 Film/Post Module (S5 Only)
- Chapter 15: Hybrid Pilot and System 5 Fusion Options
- Appendix A: Compliance Information
System 5 Digital Audio Mixing System User Guide76
Channel Processor Order
The channel process order is accessed in eMix (Masters > Process Order) and changed for pairs of channels. The upper part is for
Multi Format Masters, and the lower part is for channels.
1 Select the process and drag it to the desired position.
2 Change the process order for all channels by altering the column on the left.
3 To reset to the default process order, right-click the channel number and select Reset Process Order.
Insert Point
Each channel can have an insert point with a send and return patched with eMix. The insert point can be anywhere among the
six processors (Delay, Meter, EQ, Filters, Dynamics, and Fader) and can be considered as another processor.
The insert point can be switched in/out using the Ins In key next to the Strip’s function keys or from Input knobset page 3.
Channel processor order in Masters tab of eMix