User guide

Chapter 6: Channels and Strips 75
To display the configuration controls for processor order and patch points:
1 Press the Input function key to assign the Input controls to the knobs.
2 Press both cfg  keys simultaneously.
The cfg keys flash to show configuration mode is active.
The configuration pages display the patching and processor order for that knobset.
3 Press either of the  keys individually to navigate between the two configuration pages.
Channel Patch Points
The first configuration page assigns sources to the Key, A, and B inputs. Each input has identical controls.
All patch points are set in eMix (see “Console I/O” on page 20).
To change the source to the A input:
1 Press the A Input knob switch.
A scrolling list appears on the TFT display above the Strip.
2 Use the switches to the left of the knob to display other groups of sources.
These switches function as page up/down keys in this mode. Each group is an internal digital or MADI connection that can
contain up to 56 audio sources.
For example, one group could be mic inputs, another inputs from a digital multitrack machine.
3 Use the knob to scroll the list to highlight the desired input.
4 Press the knob switch to select that input.
5 Exit configuration mode by pressing both cfg  keys simultaneously.
They stop flashing to show configuration mode is no longer active.