User guide

Chapter 6: Channels and Strips 73
All Mode
When All mode is active on a Strip, that Strip’s function and Swap keys operate on all channels currently mapped to the console. This
mode changes only which parameters are currently displayed. For example, assigning EQ to one Strip’s knobs assigns EQ to all
Strip knobs. However, setting EQ parameters on a Strip does not change the EQ on other Strips.
To activate All mode:
1 Hold down the Wave key and press the Clear key at the top of the Strip (above the top knob’s display).
All appears above Clear.
2 Press any function key (i.e., EQ, Dyn, etc.) on that Strip and all knobsets on the console display that function.
3 Press Swap to toggle all Strips between their Main and Swap levels.
4 Hold down the Wave key and press the Clear key again to disable All mode.
Another method to activate ALL mode:
1 Press the All key on the CM401T.
The All key lights and All mode is enabled.
2 Press the All key again to disable All mode.
Link Key
Linking supports altering multiple parameters by changing the value of one of them.
Copy and Paste
Settings from one channel may be copied and pasted to others.
To copy the settings:
1 Press and hold the Wave key down and press the Copy key.
The Strip dims and the Copy key flashes.
2 Press the Func Select key (to the left of the * key) to copy the function currently assigned to the knobs to the copy buffer.
Other functions can be added to the buffer by pressing their function keys.
3 Press and hold the Wave key down and press the Copy key to stop it from flashing and exit the mode.
To paste the settings to a new channel:
1 Select the Swap or Main channel within the desired Strip.
2 Press and hold the Wave key down and press the Paste key on the new channel.
The copied information is pasted to the channel on the new Strip.
Talk (S5B Only)
Holding down the Talk key switches the talkback mic into the channel’s Mix Minus output.
See page 121 for a full explanation of the Link key.