User guide
Table Of Contents
- Contents
- Introduction to System 5
- Master Facilities and Channel Strip
- Control, Layouts and Snapshots, and Linking
- Chapter 8: Machine Control (S5P Only)
- Chapter 9: Control Groups and Multi Format Masters
- Chapter 10: Layouts and Snapshots
- Chapter 11: Linking (S5P Only)
- Chapter 12: Dynamic Automation (S5P Only)
- Chapter 13: GPI/O Event System
- Chapter 14: CM403 Film/Post Module (S5 Only)
- Chapter 15: Hybrid Pilot and System 5 Fusion Options
- Appendix A: Compliance Information
System 5 Digital Audio Mixing System User Guide58
Copy, Paste, and Clear
To copy:
1 Select the channel to copy by pressing its Wave key.
That channel is attentioned to the CM401T.
2 Press and hold the Copy key.
The Copy key lights red.
3 Select the channel to copy again on the CM402T and release the Copy key.
All other channels on the CM402T dim, and the Copy key flashes.
4 Select a function, multiple functions or the entire channel.
To paste:
1 Press and hold the Paste key.
2 Select a function or channel to paste to.
To clear:
1 Press and hold the Clear key.
2 Select a function or channel to clear.
Knobset Panels
The Center Section’s knobsets extend access to the Center Strip’s functions. The two panels (12 knobs each) above the Channel
Select Panel are dedicated to dynamics (left) and EQ (right). The two panels (eight knobs each) above the Knobset Control Panel
display different combinations of Aux, Input, and Filters depending on the preset selected from the Knobset Control Panel.
Use the Clear operation with caution. Data is not copied during a Clear operation.
Center Panel knobsets
Dynamics Panel
EQ Panel
Knobset Control
Panel