User guide

Chapter 5: CM402T Expanded Channel Module 55
Chapter 5: CM402T Expanded Channel Module
The CM402T module (see figure on next page) is located to the left of the CM401T Master Section that contains the Center Strip.
The CM402T expands access to Strip functions, so they are more readily available than from their normal Strip.
The CM402T includes the following functional sections, from top to bottom:
• Bus Routing and Track Arming Panels
See “Bus Routing Panel” on page 60 and “Track Arming” on page 106.
• Aux, Input, and Filters knobsets with Select Panel
The Select Panel determines which Center Strip channel functions are displayed on the knobsets.
• Dynamics and EQ knobsets
The Center Strip channel’s dynamics and EQ are always displayed on these knobsets.
• Channel Select Panel
• Eight assignable Strip faders
These are traditionally used for Control Groups but any channel can be assigned using the same techniques used to assign a
Strip on the CM408T.
Any console Strip channel can be displayed on the Center Strip by pressing its Wave key. The Channel Select Panel can also assign
channels to the Center Strip.
Assigning a Strip to the Center Strip has the following implications for the original Strip:
• Reassigning the Swap or Main channels on the original Strip is not reflected in the Center Strip.
• Reassigning the Swap or Main channels on the Center Strip is not reflected in the original Strip.
• The original Strip can still control its functions.