User guide
Table Of Contents
- Contents
- Introduction to System 5
- Master Facilities and Channel Strip
- Control, Layouts and Snapshots, and Linking
- Chapter 8: Machine Control (S5P Only)
- Chapter 9: Control Groups and Multi Format Masters
- Chapter 10: Layouts and Snapshots
- Chapter 11: Linking (S5P Only)
- Chapter 12: Dynamic Automation (S5P Only)
- Chapter 13: GPI/O Event System
- Chapter 14: CM403 Film/Post Module (S5 Only)
- Chapter 15: Hybrid Pilot and System 5 Fusion Options
- Appendix A: Compliance Information
System 5 Digital Audio Mixing System User Guide46
Listenback
Press the Lsn key at the bottom of the Comms:Talkback Panel to display the Comms:Listenback Panel.
The listen mics can feed any combination of the CR Main, Alt1, Alt2, or Mon A–D speakers by activating their keys on the top
half of the Panel. Activate Lsn>Flw to route the listen mics to the active CR Speaker.
Activate the DimCR key to dim the CR Speaker by the level set for the DIM key when the listen mics are on (see “Dim and Cut”
on page 42).
Turn the listen mics on/off by pressing the 1>Lsn – 4>Lsn keys on the left of the Panel. Turn all listen mics on/off by pressing the
All>Lsn key. The on/off keys are momentary unless Lsn Ltch is active.
Set the listen mic levels by pressing one of the Lsn1 – Lsn4 xx.x keys on the right of the Panel and using the SpinKnob to set the
level.
Comms:Listenback Panel