User guide
Table Of Contents
- Contents
- Introduction to System 5
- Master Facilities and Channel Strip
- Control, Layouts and Snapshots, and Linking
- Chapter 8: Machine Control (S5P Only)
- Chapter 9: Control Groups and Multi Format Masters
- Chapter 10: Layouts and Snapshots
- Chapter 11: Linking (S5P Only)
- Chapter 12: Dynamic Automation (S5P Only)
- Chapter 13: GPI/O Event System
- Chapter 14: CM403 Film/Post Module (S5 Only)
- Chapter 15: Hybrid Pilot and System 5 Fusion Options
- Appendix A: Compliance Information
Chapter 3: eMix Application 33
Diagnostics
When a system error occurs and the Diagnostics page is not displayed, the Wave logo and top-screen border flashes. Click the
Wave logo at the bottom left corner of the main eMix screen to display the Diagnostics page.
If a control module shows an error condition:
1 Press its Reset button.
A dialog box appears requesting that you resynchronize the system.
2 Click Yes and the system will function normally again.
Masters
See Chapter 7, “Busses and Bus Masters.”
Conform
See Chapter 12, “Dynamic Automation (S5P Only).”
Events
See Chapter 13, “GPI/O Event System.”
Diagnostics window
Ctrl+Alt+F12 disables the diagnostics system warning.