User guide
Table Of Contents
- Contents
- Introduction to System 5
- Master Facilities and Channel Strip
- Control, Layouts and Snapshots, and Linking
- Chapter 8: Machine Control (S5P Only)
- Chapter 9: Control Groups and Multi Format Masters
- Chapter 10: Layouts and Snapshots
- Chapter 11: Linking (S5P Only)
- Chapter 12: Dynamic Automation (S5P Only)
- Chapter 13: GPI/O Event System
- Chapter 14: CM403 Film/Post Module (S5 Only)
- Chapter 15: Hybrid Pilot and System 5 Fusion Options
- Appendix A: Compliance Information
System 5 Digital Audio Mixing System User Guide172
Dual Joystick Panel
The Dual Joystick Panel houses two joysticks in a full-width panel mounted in the CM403 module.
Assigning a Channel to a Joystick
Assign a channel to the joystick with the same key strokes used to assign a channel to a strip (see page 69).
Joystick Assign Mode
The Joystick Assign Mode is in Strip Config Panel Page 3 (see below).
Joystick Panel controls (only one joystick shown)
Joystick Assign Mode
100%
C1
Pan
L/R
Snd
F/B
Link
Solo
Pan Engage
Surround Engage
Link Key
Turns joystick
motor on and off
Joystick
Select/Punch key
Wave key is used with
Select/Punch key to set
automation mode, link to
a strip, or lock from layouts
Joystick position matrix
is 19 x 19 LEDs. A
single green LED
indicates the current
position and a diamond
represents the
Select key
Channel
Display
Solo Channel
Activates the joystick
– when off, channel is
not being controlled
underlying automation.
Strip Config 3
Joystick Assign Mode
Cycle
Direct Assign
402 Cycle