User guide
Table Of Contents
- Contents
- Introduction to System 5
- Master Facilities and Channel Strip
- Control, Layouts and Snapshots, and Linking
- Chapter 8: Machine Control (S5P Only)
- Chapter 9: Control Groups and Multi Format Masters
- Chapter 10: Layouts and Snapshots
- Chapter 11: Linking (S5P Only)
- Chapter 12: Dynamic Automation (S5P Only)
- Chapter 13: GPI/O Event System
- Chapter 14: CM403 Film/Post Module (S5 Only)
- Chapter 15: Hybrid Pilot and System 5 Fusion Options
- Appendix A: Compliance Information
Chapter 8: Machine Control (S5P Only) 101
Chapter 8: Machine Control (S5P Only)
The center section Machine Control Panel contains System 5’s Transport and Locate functions. Use the figure below as a refer-
ence for this chapter.
Machine Control Panel
hr min
bar
sec / ft
beat
fr / msec
tick
locate time
Time
Display
+
Edit
Trim
+
-
-
Trim
Locate
Reg’s
78 9
45 6
12
0
Clear
Lo c
ReturnJog
Auto
Punch
Roll
Back
Rec
Trim
Shuttle
Reh
Enter
3
Cue
Store
Current
Recall
Delete
12:24.03.10
00:16.12.04
Store
Locate
Mark
In
Mark
Out
Transport
Jog Wheel
Shuttle key
Trim key
Jog key
Time Display
Locate Time
Trim - key
Trim + key
Title Start
Previous Cue point
Next Cue point
Controls
Cue key
Display
Locate Reg’s key