User guide
Table Of Contents
- Contents
- Introduction to System 5
- Master Facilities and Channel Strip
- Control, Layouts and Snapshots, and Linking
- Chapter 8: Machine Control (S5P Only)
- Chapter 9: Control Groups and Multi Format Masters
- Chapter 10: Layouts and Snapshots
- Chapter 11: Linking (S5P Only)
- Chapter 12: Dynamic Automation (S5P Only)
- Chapter 13: GPI/O Event System
- Chapter 14: CM403 Film/Post Module (S5 Only)
- Chapter 15: Hybrid Pilot and System 5 Fusion Options
- Appendix A: Compliance Information
Chapter 7: Busses and Bus Masters 97
Bus Master Inserts
Each Group, Mix, and Aux Bus has an insert point. See “Mix Bus Send/Return” on page 25 to learn about bus insert send and re-
turns specified in PatchNet.
To switch the insert in/out:
1 Press the Aux Mstrs, Grp Mstrs, or Mix Mstrs button to display that bus on the Bus Master knobset.
2 Press both cfg and keys simultaneously.
3 Press the lower button to the left of the knob to activate that bus insert (In: button lit).
4 Press the button again to deactivate the bus insert (Out: button not lit).
This procedure works the same for Aux, Mix, and Group busses.
Mix and Group Bus Setup
See “Busses” on page 26 to learn about how to configure the Mix and Group Busses.
Bus Processing
Digital processing can be performed on up to 16 Mix, Group, or Aux busses. Processing functions include: limiter, compressor,
and filters. The selected busses (see figure below) can be assigned to a channel Strip for processing. Changing the bus processing
order affects all busses.
Bus Processing functions