Specifications

System 5 and Pro Tools Guide8
5 Click OK. You do not need to configure any other Ethernet Controllers settings. These settings do
not apply to EUCON.
Pro Tools scans your system until it identifies attached EUCON-compatible hardware. When
Pro Tools finishes scanning your system, your controllers are ready to use with Pro Tools.
Confirm Installation
To confirm installation and communication:
1 Make sure you have enabled EUCON as explained in “Enabling EUCON in Pro Tools” on page 7.
2 Open a Pro Tools session if one is not already open.
3 On the System 5 CM401 Main Panel, select EUCON Setup and attach to your Pro Tools workstation.
(If you do not know how to attach a workstation, see “Attaching the Pro Tools Workstation to System
5” on page 10.)
4 Verify the Pro Tools Mix window displays a blue-green border around all Pro Tools tracks.
5 Verify that the CM401 Main Panel EUCON channels display the correct Pro Tools tracks.
Using System 5 with Pro Tools version 8.x and lower utilized the HUI (MIDI Controller) protocol. This
is no longer necessary with Pro Tools 9.0 and higher.
Color outlines in the Mix window showing currently-banked tracks
See the Pro Tools Installation Guide for system optimization recommendations.