Installation guide

System 5 Installation Guide8
TT002B
The TT002B is a single-port, RS422 (Sony 9-pin) USB device and MMC machine controller that ships with all System Computers.
The TT002B locks to a machine and reads LTC more quickly than the devices it replaced (TT002, TT007, MOTU Midi Interface,
and GP132). To control more than one machine, a Sound Master, Colin Broad RM6, or similar device is required.
The System 5 software can auto-sense the TT002B. The setup options are done from the Machines page on the CM401T, and the
System Preferences Page. The timecode source, frame rate, track arming length, and fast forward/rewind speeds can all be set from
the System Preferences page. The CM401T TFT displays the selected frame count and incoming frame rate.
A TT003 machine controller is available for dual-operator System 5 configurations. It is physically different from the TT002 and
requires different firmware. An additional USB port is provided to connect the two System Computers.
The following diagram shows the TT002B’s GPI circuit.
TT002B GPI input and output circuit diagrams
The TT002 is not a synchronizer.