Installation guide

System 5 Installation Guide18
System 5 Module and Component Summary
System 5’s components are summarized in the table below.
System 5 Modules, Console, and Components
Component Function Number Notes
CM401T
Master Module
These two modules comprise the center section of the console.
The CM402T offers eight additional channels.
1 required
CM401T includes TB Mic and expan-
sion port to wire TB external
switches.
CM402T Expanded
Channel Module
optional
CM403
Film/Post Module
Houses joystick panner and film monitor panels. optional Ethernet device
CM408T
Eight-channel
Module
Contains 8 physical faders that control two layers of 8 inputs. 1 required Ethernet device
CM411
VGA Input Module
VGA flat display inside module; can be configured with joysticks. optional
VGA display device with serial port
option for joysticks.
CM409F
Module
Full, blank console section. optional Serial device
CM409H
Module
Blank half-width console section. optional Serial device
CM409HTP
Track Panner
Module
Half-width console section with trackball panner. optional Serial device
TT002B
Machine control Interface; GPIO controller;
Housed in the SC264 System Computer.
required
Video sync recommended for 9-pin
operation
MC524
Monitor Interface
Analog monitor output controller 1 required
TCC connection to Interface Pilot.
1 MA703 is required (standard).
ML530
Mic-Line Interface
24 remote-control mic preamps 7 max 1 AM713 is required per ML530.
SC264
System Computer
Master system computer configures DF66/DF70 and controls
MC524, ML530, and integrated DAWs.
Houses the TT002B machine and GPIO controller.
1 required
Ethernet device. Connects to control
room display monitor (optionally
CM411), keyboard, and trackball.
SC264D
System Computer
Master system computer controls MC524, ML530, and inte-
grated DAWs. Houses up to 2 DSP Line Cards, TT002 machine
and GPIO controller.
1 required
Ethernet device. Connects to control
room display monitor (optionally
CM411), keyboard, and trackball.
DF66
SuperCore
Performs all system DSP; can contain up to 6 DSP cards
1 required
(4 max)
Ethernet device. Requires digital
sync reference.
DF70
SuperCore
Performs all system DSP with eight DSP line cards. Drives up to
454 channels at 48 kHz or 222 channels at 96 kHz (depends
on Mixer Model)
optional
(2 max)
Ethernet device. Requires digital
sync reference.
CO600
Changeover Switch
MADI routing hub for Failover system optional Ethernet device
AM713
Analog to MADI
Converter
Provides 24 Analog to MADI Converters, a dual-channel Aux
Digital Input (AES/EBU or S/PDIF available), and 2 channels
Aux Analog Input.
1 required
for each
ML530
specified.
Requires digital sync reference.
MA703
MADI to Analog
Converter
Provides 24 MADI to Analog Converters, a dual-channel Aux
Digital Output (AES/EBU or S/PDIF available), and 2 channels
Aux Analog Output.
1 required
for the
MC524
Requires digital sync reference.