Specifications

S3L System Guide92
Inserting Built-In Graphic EQs on Outputs
Built-in 31-band Graphic EQs can be inserted on Mains, Groups,
Auxes, and Matrixes. 16 Graphic EQs are available.
To insert a Graphic EQ on an Output bus:
1 Go to the Outputs page and select the bus where you want to
insert the Graphic EQ.
2 Click the 31-Band Graphic Equalizer tab.
3 Click the Graphic EQ selector and choose an available mono
or stereo Graphic EQ.
The entire Graphic EQ is displayed on-screen.
Adjusting On-Screen Output Controls
The software screen Output section lets you adjust output param-
eters on-screen.
To adjust output parameters on-screen:
1 Select an output channel.
2 Adjust the on-screen controls as needed:
• For controls such as the fader and delay, click the
fader/knob and drag to adjust the parameter.
• For Mute and Polarity Invert, click the buttons to toggle
their state.
To reset an on-screen output parameter to its default value, do
one of the following:
 Alt-click the control.
– or –
 Right-click the control and choose Reset.
To reset an entire output channel to its default settings:
1 Put the system into Config mode.
2 Right-click the on-screen fader for the output you want to reset
and choose
Reset <name of output>.
Selecting a Graphic EQ
For information on configuring and using Graphic EQs, see
“Graphic EQ for Outputs” on page 156.
On-screen Output controls
Resetting a channel also deassigns any plug-in, hardware
input and GEQ assigned to the channel.