Specifications

Chapter 8: Outputs and Output Routing 91
Using Built-In EQ on Outputs
One of two EQ types can be selected for the built-in EQ, on a
per-channel basis: a full-spectrum parametric digital EQ or an an-
alog-modeled EQ. EQ can be controlled from Channel Control or
on-screen.
To use the built-in EQ on an output:
1 Select an output bus.
2 Make sure the main Channel Control menu is shown in the
Channel Control displays.
3 Press the Channel Control encoder under the display showing
EQ. EQ controls are now available on the Channel Control en-
coders.
4 Press the In switch in the Channel Control Navigation section
to toggle the EQ processor in/out.
5 Adjust the Channel Control encoders for the displayed param-
eters. An EQ response curve appears on-screen when adjusting
EQ parameters.
6 Press the Analog button on-screen to toggle between the two
EQ types.
Accessing Comp/Lim and EQ Controls On-Screen
Built-In Comp/Lim and EQ on output channels can be adjusted
using on-screen controls.
To access the built-in Comp/Lim and EQ on-screen:
1 Go to the Outputs page and select the bus you want to adjust.
2 Click the Channel tab.
Using Inserts on Outputs
Software plug-ins and graphic EQs can be inserted on Mains,
Groups, Auxes, and Matrixes.
Inserting Plug-Ins on Outputs
Plug-ins can be inserted on outputs directly from the Outputs
page.
To insert a plug-in on an output bus:
1 Go to the Outputs page and select the bus where you want to
insert the plug-in.
2 In the Inserts section of the Outputs page, do one of the follow-
ing:
• Click one of the two
Inserts pop-up menus and choose a
plug-in directly from one of the Plug-In Rack submenus.
– or –
• Click one of the two
Inserts buttons to go to the Plug-In
Rack, and route the signal to the plug-in using Plug-In Rack
controls.
The name of the plug-in insert appears in the on-screen Plug-In
Insert button.
To toggle a plug-in on/off (in/out of circuit):
1 Select the channel on which the plug-in is inserted.
2 Go to the Outputs page and click the in/out button next to the
desired plug-in to toggle it in/out of circuit. When the button
LED is lit, it indicates that the plug-in is in-circuit. When unlit,
the plug-in is out-of-circuit (bypassed).
For more information, including a description of the
on-screen EQ controls and display, see Chapter 16, “EQ.”
Output EQ control in Channel Control
Output channel Channel tab
8
Aux 8
Lo Gain
You can also insert outboard hardware. See Chapter 18,
“Hardware Inserts.”
Click to assign (left); click to go to the plug-in rack (right)
For complete instructions on plug-ins, see Chapter 17,
“Plug-Ins.”
Plug-In In/Out button