Specifications

Chapter 7: Inputs and Input Routing 79
48V (Phantom Power)
48V phantom power can be applied to any analog input assigned
to an Input Channel or FX Return.
To apply 48V from the Channel Control:
1 Select an input channel.
2 Make sure the Channel Control main menu is shown in the
Channel Control displays.
3 Press the Channel Control encoder under the display showing
Input.
4 Press the Page > Channel Control Navigation switch to assign
the second page of input parameters to Channel Control.
5 Under the display showing 48V, press the corresponding en-
coder
In switch to toggle phantom power for the selected chan-
nel in/out.
Pan/Balance
Pan adjusts channel pan (for mono channels) and stereo balance
(for stereo channels). On stereo channels, width controls are pro-
vided. A channel’s pan/balance/width setting is indicated in its
corresponding channel display.
To adjust channel pan/balance from the channel encoders:
1 Bank Input Channels and/or FX Returns.
2 Press the Pan Channel Encoder Assign switch to assign
pan/balance to the Channel encoders.
3 Rotate the encoder under the display showing Pan/Balance.
To adjust channel pan/balance from Channel Control:
1 Select one or more Input Channels or FX Returns.
2 Make sure the Channel Control main menu is shown in the
Channel Control displays.
3 Press the Channel Control encoder under the display showing
Input.
4 Rotate the encoder under the display showing Pan/Balance.
Stereo Width
Width adjusts the stereo image of stereo Input Channels and
FX Returns by controlling ganged pan positions of the left and
right channels, in opposite directions.
Width can be adjusted from full L–R, to mono, to full reversed
L–R. Width controls are not available on mono channels.
To adjust width of a stereo channel from the channel encoders:
1 Bank Input Channels and/or FX Returns.
2 Press the Pan switch in the Channel Encoder Assign section to
assign control of balance to the channel encoders.
3 Press a channel encoder Sel switch to assign width control to
that channel encoder.
4 Rotate the corresponding encoder to adjust the width for the
corresponding channel.
To adjust width of a stereo channel from Channel Control
1 Select one or more input channels.
2 Make sure the Channel Control main menu is shown in the
Channel Control displays.
3 Press the Channel Control encoder under the display showing
Input.
4 Rotate the encoder under the display showing Width.