Specifications

Chapter 6: Options 61
Solo and Monitor Operations
These settings customize Solo and Monitor bus mode and opera-
tion.
To configure Solo settings on-screen:
1 Go to the Options page and click the Busses tab.
2 Configure settings as needed:
Matrixes
The Matrixes section lets you link and unlink Matrix to form ste-
reo Matrix busses.
Links When enabled, these options link corresponding mono Ma-
trix busses into stereo-linked pairs. Control changes then affect
both mono Matrix busses.
Panning
The Panning section provides control over center channel diver-
gence when the Main Bus is set to L–C–R mode, and Stereo
Group Mode settings.
Center Divergence
When the Main busses are set to L–C–R (Left-Center-Right)
mode, the Center Divergence setting determines amount of cen-
ter-panned signal sent to the center output.
To set Center Divergence:
 Enter a value or drag in the Center Divergence text box and
press Enter.
Pickoffs
The Pickoffs tab lets you control the bus pickoff point on input
strips, as well as specify source and insert points for output bus-
ses. The Pickoffs tab also provides master control for Delay Com-
pensation.
Delay Compensation
Three settings for Delay Compensation are provided, as follows:
Off No Delay Compensation is applied.
Mix Only VENUE automatically compensates for delays incurred
by the use of Groups routed to the Main busses.
Mix and Inserts VENUE automatically compensates for delays
incurred by the use of plug-ins as well as those incurred by the use
of Groups routed to the Main busses.
Throughout this guide, other Pickoff options are explained where
relevant.
Solo controls on the Options > Busses tab
For more information, see “Configuring Solo and Monitor
Options” on page 130
For more information on these features see Chapter 11, “Ma-
trix Mixers.”
For more informations, see “Mains Center Divergence Op-
tions” on page 94.
Pickoffs tab of the Options page
Delay Compensation can be set in either Show or Config
mode.