Specifications

S3L System Guide52
Using Channel Control
Using Channel Control is as simple as selecting a channel, assign-
ing a processing function to Channel Control, and adjusting the
available parameters.
To start using Channel Control:
1 Make sure the Channel Control main menu is shown in the
Channel Control displays. If necessary, press the
Back/Top
Channel Control Navigation switch to return to the Channel
Control main menu.
2 Select a channel to target it for processing in Channel Control.
3 In the Channel Control section, press the Channel Control en-
coder under the display showing the function you want to ad-
just. For example, to adjust a built-in channel EQ, press the
encoder under the display showing
EQ.
The parameters for that processing function appear in the Chan-
nel Control displays.
4 Do any of the following to adjust parameters:
• Rotate the Channel Control encoder under the display
showing the parameter you want to adjust. For example, to
adjust the gain for the low band of a channel EQ, rotate the
encoder under the display showing
Lo Gain.
• Press a Channel Control encoder
Sel switch to adjust a sec-
ondary parameter using that encoder, where available. For
example, to adjust the Q (bandwidth) of the low band of a
channel EQ, press the encoder
Sel switch under the display
showing Lo Freq, and rotate the encoder.
• Press a Channel Control encoder to enable a secondary pa-
rameter, where available.
To bypass an individual parameter (toggle in/out):
 Press an encoder In switch to toggle an individual parameter
in/out (such as toggling an individual EQ band in/out).
• When lit, the parameter is in (enabled).
• When unlit, the parameter is out (bypassed).
To reset an individual parameter to its default setting:
 Press and hold Default and press the Channel Control encoder
for the parameter you want to reset (such as resetting the
Comp/Lim threshold to 0 dB).
Back/Top Channel Control Navigation switch
Channel Control encoders
User
Input
EQ
Ch 1
Expnd
Top
In
Back
Page
Page
1
EQ
CompLim
ExpGate
Aux 1
Channel Control display showing the Lo band EQ parameter
Lo frequency band enabled (lit Channel Control encoder In switch)
Default switch
1
Ch 1
Lo Gain Lo Freq
Lo Gain
Multi Select
SHIFT
Default
CTRL
Fine
ALT
Command