Specifications

S3L System Guide46
Selecting Multiple Channels
(Multi-Select)
Multi-Select lets you select multiple channels in order to apply an
action to them in one step, such as turning Aux sends on or off for
multiple channels.
To select multiple channels from the console:
1 Press and hold the Multi-Select switch (located on the bottom
left of the console).
2 Press the channel strip Sel switch on each channel you want to
include in the selection.
3 Release the Multi-Select switch. The flashing Multi-Select,
OK and Cancel switches, and the banner display at the lower
left of the screen flash to indicate Multi–Select mode is en-
abled.
4 Perform a routing assignment or other function (for example,
press a Bus Assign switch on one of the included channels).
The operation is applied to all selected channels.
To exit Multi-Select mode, do one of the following:
 Press the Multi-Select switch.
– or –
 Press the Cancel switch.
To select multiple channels on-screen:
 Press and hold the Multi-Select switch (or hold Shift on the
keyboard) and click the fader strips on-screen.
To select an 8-channel bank on-screen:
 Click the bank name (such as 1–8 or Aux 1–8) below the
on-screen fader strips. Shift-click to select additional banks or
channels.
To select all input channels or all output channels on-screen:
 Double-click any bank name below the on-screen fader strips
in the Input or Outputs screen.
To remove a channel from a selection:
 Control-click (or Fine-click) a highlighted channel.
Screen Controls
Adjusting On-Screen Faders
You can move on-screen faders independently or in ganged fash-
ion.
To adjust a single fader on-screen, do one of the following:
 Drag a fader in the on-screen channel strip section at the bot-
tom of the screen.
– or –
 Select a channel and move its fader in the on-screen selected
channel controls.
To move multiple faders on-screen in ganged fashion:
1 Select multiple channels on-screen by Shift-clicking.
2 Move the fader on one of the selected channels.
The faders on the selected channels will move in ganged fashion.
Any offset between the faders is maintained until at least one of
the faders is minimized (moved to –INF) or maximized (set to
+12 dB).
You can also use the Shift key on the keyboard to select mul-
tiple channels.
Clicking a bank display to select multiple channels on-screen
You can assign multiple input channels to an Aux, Group, or
VCA using Multi-Assign. See “Assigning Inputs to Matrix
Busses” on page 76.
Click to select
banks of 8
Dragging a fader on-screen
Dragging multiple faders on-screen
Fader in
channel strip section
section
Fader in
selected channel
Selected
channels