Specifications

S3L System Guide310
6 In the Internet Protocol Properties window, select “Use the fol-
lowing IP Address” and enter the following:
• IP address: 10.0.0.2
• Subnet Mask: 255.255.255.0
• Default Gateway: (none required)
7 Click OK to close the Internet Protocol properties window.
8 Click OK to close the Network Connection Properties window.
9 Do one of the following depending on the configuration of
your network:
• If you are using a wireless network, go to “Establishing a
Wireless Connection” on page 312.
– or –
• If you are using a wired network, go to “Enabling Remote
Operation” on page 314.
Setting IP Addresses Automatically
If you are using a router that includes a DHCP server function, set
the IP addresses in VENUE and the client computer automati-
cally using DHCP
Setting the VENUE IP Address Automatically
To set the IP address in VENUE automatically:
1 In VENUE, go to the Options page and click the Interaction
tab.
2 Under Ethernet Control, click Network Settings.
3 Select Obtain Address Automatically.
4 Click Apply.
5 Wait until the VENUE System is assigned an IP address. This
may take time (up to two minutes). If no DHCP server is
found, the VENUE system will self-assign an IP address.
6 Select Enable Remote Control to activate the VENUE System
ECx host. Your system’s status will be displayed as “Waiting
for connection.”
7 Go to “Setting the Windows Client IP Address Automatically”
on page 311.
Internet Protocol Properties window
Configuring Ethernet Control in VENUE
Make a note of the IP address assigned to your VENUE sys-
tem, as you will need to enter it into the client software
.