Specifications

S3L System Guide238
Simulating a VENUE Configuration
You can use the Standalone software to simulate a VENUE sys-
tem with any number of input and outputs. The corresponding in-
puts and outputs become available in the Patchbay, allowing you
to prepare a show that can transfer directly to the destination sys-
tem.
To simulate a VENUE system:
1 Launch the Standalone software.
2 Go to the Options page and click the Devices tab.
3 Right-click the device graphics to choose the surfaces and/or
I/O you will be working with.
Transfer and Filing Quick Start
The basic steps for using the Standalone software and data trans-
fer are as follows:
• Save data to disk, then transfer it to an external USB storage
device.
• Transfer data from the USB device, then load the data.
Save and Transfer Data from a
VENUE System
To save and transfer data from the complete system:
1 Connect a USB storage device to a VENUE USB port.
2 Use the Save tab of the Filing page to save VENUE data to
disk.
3 Go to the Filing page and click the Transfer tab.
4 Do one of the following to select the type of data to transfer:
• To transfer all data, click the
Console icon.
• To transfer Console Settings (the current state of the con-
sole, equivalent to an auto-saved Show file), click the
Set-
tings
icon.
• To transfer Show Folders, click the
Show Folders icon.
• To transfer individual Shows, click the
Shows icon.
• To transfer Preset Folders, click the
Preset Folders icon.
• To transfer Presets for individual items, click the
Built-In
icon or the Plug-In icon and choose a processor, plug-in or
Input Channel Presets item from the pop-up menu, or click
the Scope Sets icon.
5 In the left column, select the items you want to transfer from
VENUE to the portable storage device.
6 Click the Transfer button.
For complete instructions on transferring data, see
Chapter 19, “Shows and File Management.”
Transferring Show files from VENUE