Specifications

S3L System Guide12
Connecting Power
S3 Control Surface
The external PSU for the S3 control surface is connected to the
DC input on the S3 and to your power source.
To connect power to the S3 control surface:
1 Connect one end of the included IEC power cable from the ex-
ternal PSU to your power source. Make sure the power cable is
pushed all the way into the PSU.
2 Connect the cable with the 4-pin connector that is attached to
the PSU to the DC power input on the back panel of the S3. To
correctly align the pins on the connector with the power input,
make sure the arrow on the connector faces up.
E3 Engine
The AC power input for the E3 engine is located on the back
panel.
To connect power to the E3 engine:
 Connect the included IEC power cable from the AC power in-
put on the back panel of the E3 engine to your power source.
Stage 16
The AC power input for the Stage 16 is located on the back/bot-
tom panel of the box. One male, 3-pin North American standard
IEC power socket with cable retaining tie is provided. The input
and power switch are recessed to allow the box to sit on its back.
To connect power to the Stage 16:
1 Connect the included IEC power cable from the AC power in-
put on the back of Stage 16 to your power source.
2 (Optional) Secure the power cable to the rack using the built-in
cable tie.
Connecting the IEC power cable to the S3 control surface PSU
S3 control surface DC power input
E3 engine AC power input
A B
1-2 3-4
AES OUTPUT
INPUTOUTPUT
Stage 16 AC power input, power switch, and cable tie