Specifications

Chapter 20: Snapshots 193
Recalling Snapshots
Targeting Snapshots
Targeting a snapshot lets you preview which data types and chan-
nels will be affected by that snapshot before recalling it. When a
snapshot is targeted, the on-screen Data Type buttons and Chan-
nel Faders update to show the data types and channels enabled for
recall by the snapshot.
To target a snapshot, do any of the following:
 Click the snapshot name in the Snapshot list.
 Type the number or name of the snapshot on the keyboard.
 Press the Home/End, Page Up/Page Down, and Up/Down Ar-
row keys on the keyboard to navigate the Snapshot list.
The current target snapshot is highlighted in red in the Snapshots
list, and shown in red in the Status display.
Recalling Snapshots
You can do the following when recalling snapshots:
• Target and instantly recall successive snapshots (next or
previous)
• Target first, then recall one or more snapshots
• Select multiple snapshots and recall them all sequentially
• Target snapshots, change Data Type or Channel Scope set-
tings, then recall.
Recalling Successive Snapshots Instantly
You can instantly recall successive snapshots in the Snapshots
list. This command references the currently recalled snapshot, not
the targeted snapshot.
To instantly recall successive snapshots on-screen:
 On-screen, click the Recall Previous (–) or Recall Next (+) but-
ton at the top of the Snapshots list.
Targeting Before Recalling Snapshots
To target and then recall a snapshot:
1 Click the snapshot name in the Snapshot list.
2 (Optional) Set the scope of the snapshot by doing the follow-
ing:
• For each channel you want to recall in the snapshot, click
the channel so that it is scoped (displayed in red).
• For each parameter of the scoped channels you want to re-
call in the snapshot, click the corresponding
Data Type but-
ton so that it is scoped (displayed in red).
• Configure the Recall Safe tab to further filter snapshot data
on recall. (See “Recall Safe” on page 194.)
3 Click the Recall button on-screen.
Preview mode lets you take the system controls offline to re-
call and edit snapshots in their entirety without affecting the
current mix. See “Preview Mode” on page 202.
Undoing snapshot recall commands might cause audio to be
interrupted. Use Undo with caution in performance.
The Snapshot Recall buttons combine target and recall
actions in one step, causing the previous or next snapshot to
be instantly active. These buttons cannot be used to
preview snapshots before recalling them.
Snapshot Recall can also be triggered by a footswitch or any
number of other functions using events. For more informa-
tion, see Chapter 21, “Events.”