Specifications

S3L System Guide162
Installing Plug-Ins
To install a plug-in:
1 Insert the USB drive containing the plug-in installer(s) into an
available USB port on the E3 engine.
2 Go to the Options page and click the Plug-Ins tab. The follow-
ing two lists are shown (see Figure 1):
Plug-Ins to Install This list shows available plug-in installers. At
the top of the list is the Device selector, which provides a pop-up
menu of available media sources. Plug-In installers are stored lo-
cally after plug-in installation, and appear as available items
when Previous Installs is selected from the Device selector. This
lets you re-install plug-ins without the original plug-in installer.
Installed Plug-Ins This list shows all plug-ins already installed on
the system. The plug-ins shown in plain text are available to pro-
cess audio. Plug-Ins listed in italics are disabled and unavailable
(see “Enabling and Disabling Installed Plug-Ins” on page 164).
3 In the Plug-Ins to Install list, click the device selector pop-up
menu and do one of the following:
• Choose
Previous Installs to access any plug-in installers af-
ter a system update.
• Choose
Console to access all factory-installed plug-in in-
stallers after a system update or a full system restore.
• Choose an external storage device, as available, to access
plug-in installers on drives connected to the E3 engine.
4 Select a plug-in from the Plug-Ins to Install list on the left by
doing any of the following:
• Click to select a single installer.
• Shift-click to select multiple consecutive installers.
• Control-click to select or deselect installers one at a time.
5 Click Install to install the selected plug-ins. Once installed, the
plug-in appears in the Installed Plug-Ins list on the right.
6 Repeat as necessary to re-install all plug-ins needed on the sys-
tem.
Plug-Ins cannot be installed using the USB ports on the S3
control surface.
Device selector pop-up menu
Figure 1. Options > Plug-Ins screen