Specifications

Chapter 1: Introduction to the S3L System 5
Operational Requirements
Temperature and Ventilation
S3L system devices should be operated away from heat sources
and with adequate ventilation.
Storage
S3L system devices should be stored and transported at tempera-
tures not lower than 0 degrees F (–18 degrees C) and not exceed-
ing 140 degrees F (60 degrees C).
Operation
S3L system devices should be operated at temperatures not lower
than 40 degrees F (4 degrees C) and not exceeding 104 degrees F
(40 degrees C).
During operation, the bottom panels of the S3 control surface, the
front and back panels of E3 engine, and the side panels of the
Stage 16 should be exposed to ambient air. Do not block the ven-
tilation holes on any S3L system component.
Do not operate in direct sunlight or at extreme ambient tempera-
tures.
Water and Moisture
S3L system devices should be operated away from sources of di-
rect moisture and should be kept clear of liquids that might spill
into the units. If condensation is present on the unit, leave the unit
to dry in ambient air for at least one hour before powering the unit
on.
Cleaning and Maintenance
Use a dry cloth to clean the surfaces of the S3L components. Do
not apply any cleaning solutions, spray cleaners, or abrasives to
the surface.
Connection Requirements
Power Connections
Power connections on all S3L system devices are auto voltage-se-
lecting (100 to 240V nominal, 90-260V maximal, 50–60 Hz).
Make sure your power source is correctly rated for the number of
units you are connecting. A surge-protected power source (not in-
cluded) is highly recommended.
Audio Connections
• All audio inputs and outputs (except Headphones) are bal-
anced XLR and/or balanced 1/4-inch connections.
• All 1/4-inch connections support balanced (TRS) and un-
balanced (TS) connections.
• All external digital audio inputs and outputs are AES/EBU
(XLR) connections.
Audio Network Connections
Shielded Cat 5e (350 MHz) or better Ethernet cable with Neutrik
etherCON
connectors are required for primary and redundant au-
dio network connections between the console, the E3 engine, and
any Stage 16 boxes. Maximum distances of 100m are supported
for all audio network connections.
Pro Tools Connections
Shielded Cat 5e (350 MHz) or better Ethernet cable with RJ-45
connectors is required for the Ethernet AVB connection to
Pro Tools.
ECx Ethernet Control Connections
Standard Cat 5e Ethernet cable with RJ-45 connectors are sup-
ported for ECx remote control connections to a client computer or
wireless/wired router.
System Requirements and
Compatibility
Avid can only assure compatibility and provide support for hard-
ware and software it has tested and approved. For complete sys-
tem requirements and a list of qualified computers, operating sys-
tems, hard drives, and third-party devices, visit:
www.avid.com/compatibility
Hardware monitoring and automatic warnings are provided
for temperature, power and other factors. For more informa-
tion, see “Hardware Monitoring Window” on page 294.
Storage humidity range 5% to 95%, non-condensing
Operating humidity range 20% to 80%, non-condensing
For more information on audio connectors and specifica-
tions, see Chapter 27, “Audio Specifications.”