Specifications

S3L System Guide136
To activate and set the level for the Talkback from the Global
Control encoders:
1 Press the Monitoring Global Control encoder to assign Talk-
back controls to the Global Control encoders.
2 Under the Global Control display showing Talkback, press the
corresponding encoder
In switch to turn the Talkback circuit
on.
3 Rotate the corresponding encoder to set the Talkback level.
Setting Talkback Dim Level
When Talkback is sent directly to an Output bus, the bus program
material (minus the talkback signal) is automatically reduced by
the amount specified in the Dim Level setting.
To set the Talkback Dim Level:
1 Go to Options > Misc.
2 In the Talkback section, double-click the Dim Level text box
and enter a Dim Level value in the range –60 dB (maximum
gain reduction) to 0 dB (no gain reduction).
Using 2-Track Inputs
You can route a pair of Console or Engine analog or digital hard-
ware inputs directly into output busses using the 2-Track inputs.
This allows you to send audio to the selected outputs without us-
ing a system channel. Use this feature to perform tasks such as
confirming system audio output.
Routing 2-Track to Output Busses
To route 2-Track inputs to output busses:
1 Go to Options > Misc.
2 In the 2-Track section, click the Input Fed to Monitors and
Masters
pop-up and select a hardware input source.
3 Click Route. The switch flashes to indicate Route to Selected
mode.
4 Go to the Outputs page and click one or more output fader
strips. The selected fader strips flash.
5 In the confirmation dialog that appears, click Route to confirm
your assignment or click
Cancel to cancel without changing
the current routing.
Activating 2-Track Input and Setting Level
The 2-track input can be adjusted on-screen or from the Global
Control encoders.
To activate and set level for the 2-Track inputs on-screen:
1 Go to Options > Misc.
2 In the 2-Track section, click the on-screen In button to activate
the 2-track input.
3 Drag the on-screen Level knob to set the level of the.
To activate and set level for the 2-Track inputs from the Global
Control encoders:
1 Press the Monitoring Global Control encoder to assign 2-track
controls to the Global Control encoders.
2 Under the Global Control display showing 2-Track, press the
corresponding encoder
In switch to activate the 2-track circuit.
3 Rotate the corresponding encoder to set the 2-track input level.
Talkback, 2-Track and Oscillator States
When Loading Shows
When you load a Show file, Talkback, 2-Track and Oscillator
controls are set to off (deactivated), regardless of their state when
the Show was last saved.
Choosing a 2-track input